Tandem Center 4-Way Control Valve used with Huck Tooling

1. Turn the valve control lever to the NEUTRAL position. (Fig. 1)

2. Start the pump by pressing the motor control ON/OFF switch. (Fig.1)

3. Turn lever to Pull Side, Huck tool will pull back installing the fastener. (Cutting the collar if cutter nose

 is used) (Fig. 1 & 4)

4. Turn lever to Return Side, Huck tool will return to full forward position pushing off collar (releasing

 cutter if used). (Fig. 1 & 2)

 NOTE: The cylinder momentarily loses pressure during the transition between valve positions.

5. Turn the valve control lever to the NEUTRAL position. Shut pump off by pressing the motor control

 ON/OFF switch. (Fig. 1)

NOTE: Refer to SPX Manual for all other information