Hand Installation Tools
Recoil® Threaded Mandrel Pre-Winder Installation Tools or Helicoil® Inserting Tool
This type of Recoil® tool is ideal for installing inserts in small production runs or in areas where compressed air or electricity is not available and offers a quicker alternative to the simple hand installation tool. The Recoil® tool or Helicoil® tool is suitable for use when installing free running and locking inserts.
Recoil® tool mandrel is wound into the insert, which is then installed into the tapped hole. During installation, the insert diameter is reduced when passing through the bottom of the pre-winder tool chamber, making it easier to install. The mandrel is removed by turning the crank in a counter-clockwise direction, leaving the insert in place.
Threaded Mandrel Type
The Recoil® threaded mandrel type tool is suitable for the installation of free running and locking inserts. The Recoil® mandrel is wound into the insert, which is then wound into the tapped hole. The Recoil® mandrel is removed by turning the crank in a counter-clockwise direction, leaving the insert in place.
Note: The Recoil® threaded mandrel type installation tool is recommended for installing locking inserts.

(0)
( 12 Available )
$15.7333
Availability
(0)
( 132 Available )
$16.70
Availability
(0)
( 26 Available )
$178.3467
Availability
(0)
( 5 Available )
$178.3467
Availability
(0)
( 93 Available )
$15.1833
Availability
(0)
( 13 Available )
$70.70
Availability
(0)
( 6 Available )
$15.7333
Availability
(0)
( 33 Available )
$24.1167
Availability
(0)
( 1 Available )
$70.70
Availability
(0)
( 8 Available )
$78.9143
Availability
(0)
( 1 Available )
$70.70
Availability
(0)
( 17 Available )
$73.2714
Availability
(0)
( 0 Available )
$31.2333
Currently On Backorder. Please See Substitute/Alternative Items Below
(0)
( 11 Available )
$78.9143
Availability
(0)
( 5 Available )
$70.70
Availability