Marson® M39043 MJN-2 Quad Leg Nut Installation Tool; 6-32, 1/4-20, M4 to M6
Brand new from Marson, the MJN-2 hand-held Quad Leg rivet nut installation tool is designed to effortlessly set Pop "Jack-Nuts" or Marson Quad Leg Nuts in sizes ranging from 6-32 - 1/4-20, and M4 - M6. It works by threading the bolt to the Jack-Nut, then dropping the component in the slot of the Jack-Nut tool, inserting it into the pre-drilled hole, and squeezing until set. Pressing the release lever, then tightening completes the installation.
The MJN-2 hand held Quad Leg blind jack nut tool is designed to effortlessly set
Quad Leg Nuts or Jack Nuts® in sizes ranging from
6-32 thru 1/4 Inch and M4 thru M-6
Thread the Quad Leg Nut or Jack Nut® onto the bolt first leaving approximately a space between the Quad Leg Nut or Jack Nut® flange and the under side of the bolt head. Place bolt head into the U shaped slot at the nose of the tool.
Insert the Quad Leg Nut or Jack Nut® into the pre-drilled hole and squeeze
handle until set. (Depending on the size it may take several squeezes to fully set).
Press the silver release lever and the installation is complete. Remove the tool and
unscrew the bolt or screw from the Quad Leg Nut or Jack Nut
Pass bolt or screw through the work that is going to be fastened and then into the
Quad Leg Nut or Jack Nut and tighten to complete installation.